I'm looking for information on where I could find the digital display on a 1991 Williams "Hurricane" machine, or if anyone here had one. I'm looking more for the LED upgrade, however the standard gas display would be better than nothing.

Thanks!

Pinball Life is usually the cheapest.

http://www.pinballlife.com/index.php?p=catalog&parent=18&pg=1

The LED DMD from Pinled will cost you double.

If you need something that does the trick for now, I'm sure someone on here can sell you a used one for much less.. maybe with a line out or something, but anything is better than nothing.

Although are you sure the DMD is actually the problem?  They're usually at least partially working.  Did it just stop working one day?  If so, then the DMD itself likely isn't your problem, it could be perfectly fine and you may have a board problem instead.

Just trying to help so you don't drop a few hundred bucks on something that might not need replacing  

I wouldn't go LED for a DMD.

mslave is right. You should check voltages going to the DMD before spending the money. High voltage section is notorious for failing in time and should be tested for proper output.

Quoted from necro_nemesis

mslave is right

I'm going to treasure this moment, Glen..  

Quoted from machine.slave

I'm going to treasure this moment, Glen..  

It wouldn't be so special if you were more often.

I would swap in another DMD if you can get someone to help you to see if that is the problem.

I have one with a line out that can be repaired although I am too cheap/lazy to buy silver conductive epoxy.  If you want it I would let it go for $50, or maybe $80 ish if I ever get the time to repair it.

Where are you located?

Hey guys,

No, it wasn't a voltage issue, the screen was just running low on gas, I think it was the original.

I found someone locally and already picked up a new screen. Thanks for all the replies and suggestions!

that's good news!  Congrats