I just set up my no fear lasr night and it works but all I have is gi and flashers, anything I should be looking for before i start fooling around. Paul
current pins taf,lotr,cftbl,ngg,ij,tz,totan,tspp,shadow,t2,Wh20,rs,rfm sadly gone over 30 more pins.
I just set up my no fear lasr night and it works but all I have is gi and flashers, anything I should be looking for before i start fooling around. Paul
You post is confusing. Does it work or not?
If all you have id GI and flashers did you close the coin door to enable the coils??
Mike
Currently owning: ============ MAME in Sega cab with 25" arcade monitor (Has a 12" Bazooka powered subwoofer in it) - Not for sale Williams Civic Center Shuffle Alley (Puck Bowler) (1973) - 350$ Seeburg LS1 "Spectra" Jukebox (1967) - 300$
Currently babysitting =============== Heavy Metal Meltdown SOLD - leaving soon
Previously owned ============= Hot Tip, Countdown, HS, WWF, TFTC, T2, RS, Pinbot, Laser War, LOTR, Flinstones, FH, DM, STTNG, Getaway, Silver Slugger, Laser Ball, Bad Cats, Batman Forever, Meteor, TZ, Galaxy, 6MDM, TSPP, MB.
Whats that Shap pain in my back Oh it's a Knife Complete MAACA-Wacko!
Posts
1,778
Gender
Male
Posts Per Day
0.82
Time Online
321 days 18 hours 59 minutes
Location
Gatineau
Age
32
All fuses are good conector looks fine? No hacks?
Life is like Pinball!! You never know where you will bounce or where your going but sometimes you have that one amazing shot But on the other hand you have those darn gutter ball where you just get frustrated.
GI ( general illuminations ) and cpu controlled lights, which seems to be the one you're talking about.
If none of the lamp matrix lights are working, the obvious thing to check is the fuse. If the +18 volts is missing, none of the lamp matrix lights will work and the 18 volt LED will not be lit. This is powered through bridge BR1, fuse F114, LED6, and test point TP8 (on WPC-95 games diodes D11-D14, fuse F106, LED102, and TP102).
What if the fuse is good (which would indicate the bridge/diodes are good), the LED is lit, and the test point shows 18 volts DC? Yet the lamp matrix lights don't work, or are "confused"? With the power off, reseat the short ribbon cable that goes between the CPU and driver board (this will clean the connectors on this ribbon cable). Often this simple approach will solve the problem.