What kind of vehicles do you use to move pins around? I'm stuck on that question right now. If I can get it in my Malibu Maxx, it would save me renting a van...
I'm not familiar with that car, but a pin with the head removed will fit into almost any hatchback with the rear seats folded down. Standard cabinet size is roughly 22" wide, 52" long, and 24" tall at the back. A second person to help load/unload will make it a lot easier.
Playable Now: Centaur II, Doctor Who, High Speed. Playable Soon: Breakshot, Sorcerer Later: Flash, Genie, Seawitch Fondly remembered: Firepower
You can 3 in most vans At least I could in my Windstar and still can in my Venture
Mike
Currently owning: ============ MAME in Sega cab with 25" arcade monitor (Has a 12" Bazooka powered subwoofer in it) - Not for sale Williams Civic Center Shuffle Alley (Puck Bowler) (1973) - 350$ Seeburg LS1 "Spectra" Jukebox (1967) - 300$
Currently babysitting =============== Heavy Metal Meltdown SOLD - leaving soon
Previously owned ============= Hot Tip, Countdown, HS, WWF, TFTC, T2, RS, Pinbot, Laser War, LOTR, Flinstones, FH, DM, STTNG, Getaway, Silver Slugger, Laser Ball, Bad Cats, Batman Forever, Meteor, TZ, Galaxy, 6MDM, TSPP, MB.
I usually use a trailer and my truck, I built the trailer for hauling pins and vids. We have on a couple of occasions put pins in the back of the wife's PT Cruiser with the rear seats removed.
Currently Owning: Vids- Road Blasters, Road Runner, Joust, Golden Tee 2005 Pins- Back to the Future, Theatre of Magic, Joker Poker, Grand Tour, Hyperball
Previously Owned: Vids- Far too many to list Pins- High Speedx2, The Shadow, Mystic.
"Measured" my 2006 saturn vue before driving from Toronto to Chicago to get a nice MB, having never had a pin in it before. Needless to say I was VERY nervous about getting to Chicago and it not fitting....but I thought very worst case the head could be removed. Couple things to watch for:
Don't just measure the inside height of your vehicle, make sure there is room at the hatch door...it was a tighter fit there then once in the truck.
Also the latch on my vehicle sticks up about 1/2 inch above the cargo space. Had to use a torx wrench to get the latch off otherwise getting the machine in, up/sliding over the latch would have been a pain or caused a lot of damage.
Get right in the back of your vehicle, close the hatch and then measure, don't want to have the machine fit in but then not quite be able to close the hatch or something..
Good luck!
Currently ~~ The Addams Family ~~ Monster Bash Wanted ~~ MORE! Once there is enough room! 2 pins in a 2 bed apt is enough
sentinelking
Male
Logged
At least I could in my Windstar and still can in my Venture 
MAACA ARCHIVES - JOIN THE NEW FORUM AT HTTP://WWW.MAACA.ORG › General Boards › MAACA Forum and Chat › Moving pins
